How to make the
Snapping Shark puppet

Follow the directions below and soon you will
have your very own Snapping Shark puppet.

You might like to get Mum or Dad to help you.

Place the shark paper on the table.

Fold up the bottom half so the printing
is on the inside.

I've drawn a line to show you where to fold.
Fold the top half towards you and down.

It should look like this.

Now turn the whole lot over and turn down the
other side...

It should look like this... like the letter M

Here's a side view.

With the printing on the inside, fold one
corner up as shown.

Now do the same on the other end.

You're now doing the same on the other side
except you are turning up three thicknesses
of paper.

See ... three thicknesses of paper...

Now the same on the other end. Then flatten
and turn over.

It should look like this.

You will now make a small tear, about a
centimetre deep where I've drawn the line.

Just like this. Don't make it too deep.

You will now make a fold, towards you along
the marked area.

Just like this....

Now do it revealing all four sets of teeth.



Congratulations, you're finished.
Have fun

Take me to the Donkey Puzzle Page
Take me back to the Secret Page
Take me to Take me to the Home Page